欢迎来到北京翔方电梯装饰有限公司官方网站!

全国咨询热线1526412235318866610825

公司新闻
当前位置:主页 >新闻中心 >公司新闻 >

小型乘客电梯观光/家用二层小电梯/济南电梯厂家装修

发布时间:2022-03-11点击:614文章来源:www.bjxfdtzs.cn

  济南电梯装饰:电梯常见故障(fault)分析
  Analysis of common faults of elevator
  1. 电梯无法起动------- 电源开关未接通; 三相交流电源断相或缺相; 轿门或厅门未完全关闭; 门联锁开关故障(fault); 底坑或机房急停动作后未复位或损坏; 电机接线不正确; 轿厢、装载物品或对重被卡住; 抱闸未打开或松闸间隙不正确
  1. The elevator cannot be started ----- the power switch is not connected; the three-phase AC power supply is open or missing; the car door or hall door is not completely closed; the door interlock switch is faulty; the pit or machine room is not reset or damaged after emergency stop action; the motor wiring is incorrect; the car, load items or counterweight are stuck; the holding brake (zh á) is not opened or the brake clearance is not correct.
  2. 又名空气断路器跳闸---------空气开关整定电流(Electron flow)值与马达电流不匹配; 调整抱闸; 缺、断相
  2. Also known as air circuit breaker trip (zh á) ------ the setting current of air switch does not match the motor current; adjust the holding brake; open phase and open phase.
  轿厢超载
  Car overloading
  3. 马达过热--------- 轿厢超载; 电梯运行环境温度(temperature)超过40℃; 抱闸没有办法正常释放(release); 电机短路(电流不经用电器,直接连电源两极)或抱闸短路、缺相; 电机接线错误; 轿厢或对重运行受阻
  3. Motor overheating: the car is overloaded; the operating ambient temperature of the elevator exceeds 40 ℃; the brake (zh á) cannot be released normally; the motor is short circuited (the current is not connected to the two poles of the power supply directly without the use of electrical appliances) or the brake is short circuited or the phase is missing; the motor wiring is wrong; the car or the counterweight operation is blocked.
  4. 电梯起动时阻力大,且起动和运行速度降低(reduce)----------轿厢、装载物品或对重被卡住; 制动器闸瓦未完全打开; 制动器松闸间隙太小; 滑轨(TTW guide)松动,导轨接头处发生错位; 电源电压过低
  4. When the elevator starts, the resistance is large, and the starting and running speed are reduced -------- the car, loaded goods or counterweight are stuck; the brake shoe is not fully opened; the brake release clearance is too small; the TTW guide is loose, and the rail joint is misplaced; the power supply voltage is too low.
  5. 马达起动后,瞬间即停--------- 检查保护线路
  5. Stop immediately after the motor starts ------ check the protection circuit
  6. 电梯曳引钢丝绳(由钢丝、绳芯及润滑脂组成)打滑----------制动器制动力矩小; 对重架配重太少; 轿厢超载; 曳引轮绳槽过度磨损(零部件失效的一种基本类型)
  6. Elevator traction wire rope (composed of steel wire, rope core and lubricating grease) slipping ------ brake braking torque is small; counterweight of counterweight frame is too small; car is overloaded; traction wheel rope groove is excessively worn (a basic type of component failure)
  7. 没有办法选层----------选层按钮失灵或不复位; 检查直流电源电压
  7. There is no way to select layer ------ layer selection button fails or does not reset; check DC power supply voltage
  8. 轿厢不平层----------巡查感应器内遮磁板是否拆除; 检查接线是否正确; 检查感应器是否损坏; 检查控制板是否损坏
  8. Car uneven layer -------- inspect whether the magnetic shield in the sensor is removed; check whether the wiring is correct; check whether the sensor is damaged; check whether the control panel is damaged.
  9. 显示板没有办法显示------------钥匙(key)开关损坏; 直流电源板损坏; 层显板损坏
  9. There is no way for the display board to display ----------- the key switch is damaged; the DC power board is damaged; the layer display board is damaged.
  10. 控制(control)单元无法正常工作---------- 直流电压断路或工作开关未拨至RUN档
  10. The control unit fails to work normally ------ DC voltage is open or the working switch is not set to run.
  11. 安全钳误动作-----------限速器被错误调整或出现故障; 限速器钢丝绳(由钢丝、绳芯及润滑脂组成)被卡住; 安全钳故障; 弹簧(Spring)伸长或破断; 滑轨(TTW guide)有污物
  11. Safety gear misoperation -------- speed governor is adjusted incorrectly or fails; speed governor wire rope (composed of wire, rope core and lubricating grease) is stuck; safety gear fails; spring is extended or broken; TTW guide has dirt.
  12. 厅门开、关门不灵活----------厅门变形或损坏; 钢丝绳破断或调节不均(垂直中分门);门滑道内污物太多(垂直中分门)
  12. Inflexible opening and closing of hall door ------ deformation or damage of hall door; broken wire rope or uneven adjustment (vertical split door); too much dirt in door slide (vertical split door)
  13. 轿厢到站后,厅门没有办法打开-----------门刀故障(fault); 门锁碰轮故障; 电磁门锁线圈或供电电压故障
  13. After the car arrives at the station, the hall door cannot be opened -------- fault of door knife; fault of door lock and wheel; fault of electromagnetic door lock coil or power supply voltage
  14. 电磁门刀不动作-----------电源供电不足; 电磁门刀机械部件卡阻
  14. The electromagnetic door knife does not operate -------- the power supply is insufficient; the mechanical parts of the electromagnetic door knife are jammed.
  北京翔方电梯装饰有限公司济南分公司
  联系人:龙经理
  销售热线:15264122353
  手机号码:17866605129
  QQ:467873295
  E-Mail:467873295@qq.com
  公司地址:山东省济南市历城区全福立交

首页
电话
地址